Packard-bell W7 Manuel d'utilisateur

Packard BellEasyNote W7 Series(Dragon SN)Disassembly Manual

86. Disconnect the touchpad flat cable.7. Remove the two hinge covers.8. Disconnect the lid switch connector.9. Remove the screw (1xD) and remove

9Removing the LCD Panel AssemblyFollow the steps below to remove the LCD panel:1. Disconnect the two LCD connectors.2. Release the Wireless antenna

10Fig. 15 LCD display panel.10. Disconnect the inverter backlight connector.Fig. 16 LCD inverter backlight connecter.11. Remove the lower supporting b

1115. Remove the screws (3x D, 1xA) from the left LCD bracket. The same goes forthe right bracket.Fig. 18 LCD display cable.16. Take away the top, lef

12Optical Disk DriveTo remove the optical disk drive, follow the steps below:1. Remove the screws (2xB) and push the optical disk drive out of its ba

13Bottom Base AssemblyDisassemble the bottom base assembly as follows:1. First remove the screws (4XA) from the top cover.2. Then remove the screws

144. Remove the screws from the rear (2xB).5. Remove bottom cover from base assembly.6. Disconnect the subwoofer connector.7. Remove the screws (2

158. Take away the main board.9. Partially remove the foil over the touchpad.10. Disconnect the touchpad cable.11. Remove the screws (3xB) and remov

16NoticeThe information in this guide is subject to change without notice.This guide contains information protected by copyright. No part of this guid

0Table of ContentsOverview 1Disassembly Instructions 1Reassembly Instructions 1Required Tools 1Hazardous Voltage 2Avoid Electrostatic Discharge 2Power

1OverviewThis document contains step-by-step disassembly instructions for the EasyNote W7(Dragon SN) chassis. The instructions are illustrated where n

2Hazardous VoltageThere is hazardous voltage present inside thecomputer when it is connected to an ACsupply, even when the computer’s powerswitch is o

3WAARSCHUWINGZorg er voor dat alle verbindingen van ennaar de computer (stroom, modem, netwerk,etc) verbroken worden voordat de behuizinggeopend wordt

4Battery and AC AdapterTo remove the battery, do as follows:1. Turn off the computer.2. Disconnect the AC adapter.3. Remove the battery.Removing th

5Bottom PanelPerform the following steps to remove the bottom panel:1. Remove nine screws (9xA) and take away the bottom panel.2. Remove the memory

67. Remove the screws (2xA) from the modem.8. Release the ground cable and take away the modem.9. Disconnect the modem cable from the modem.CPU, VG

76. Remove the screw from the VGA module (1xT).7. Pull the VGA module out of the MXM slot.8. Unlock the CPU socket and remove the CPU.Top CoverRemo